Prepare Finger or Finger-Over-Finger Splices

The Pun M™ is designed to effortlessly punch fingers into polyurethane and PVC conveyor belts in preparation for installing vulcanized splices. The tool is available in 3 standard widths; 12" (300 mm), 24" (600 mm) and 36" (900 mm). The open construction of the punch enables punching wider belts in multiple steps.

Ideal for Working on Location

The Pun M is manually operated and does not need electricity or air pressure for its operation. The punching force of 11,000 lbs. (50 kN) is created by pulling the lever and is easily done with one hand by an average person. Because of its easy set-up and manual operation, the Pun M is an ideal tool for working on location, as well as in a workshop.

Easy Operation - One hand clamping bar.

Flexible Configurations - For all types of finger punching.

Manually Operated - No electricity or air pressure needed.

Portable Equipment - For on-site use.

Easy Operation

To punch a belt, one belt end is positioned against the end stop and then clamped in place. Precise fingers are quickly punched with each lever pull.

Punch Types

Depending on the desired finger dimensions, Flexco offers a variety of punchboards for the Novitool Pun M™ Please note that punchboards are supplied separately. When ordering a new tool please state the desired punchboard (s).