Tensile Force for 1% Elongation (k1% Static) per unit of Width (Habasit Standard SOP3-155 / EN ISO 21181)
9.0 N/mm 51 lbs/in
Tensile Force for 1% Elongation after Relaxation (k1 % relaxed) per unit of Width (Habasit Standard SOP3-155 / EN ISO 21181)
4.2 N/mm 24 lbs/in
Min. Continuous Operating Temperature Admissible
-20 ºC -4 ºF
Max. Continuous Operating Temperature Admissible
66 ºC 151 ºF
Coefficient of Friction of Driving Pulley of Steel
0.25
Seamless Manufacturing Width
1200 mm 47 in
Product Designation
Product Group
Hamid Machine Tapes
Main Industry Segments
Folding Paper converting Paper manufacturing and processing Paper printing and finishing
Belt Applications
Folder belt Machine tape Paper handling belt
Special Features
Abrasion resistant Constant and gentle positive grip Dimensionally stable Flexibility in all directions Non-marking
Mode of Use/Conveyance
Declined Horizontal Inclined Vertical
Product Construction/Design
Conveying Side (Material)
Polyamide (PA) fabric
Conveying Side (Surface)
Fabric
Conveying Side (Property)
Non-adhesive
Conveying Side (Color)
Light gray
Traction Layer (Material)
Polyamide (PA) fabric/Hamid foil
Number of Fabrics
2
Running Side/Pulley Side (Material)
Polyamide (PA) fabric
Running Side/Pulley Side (Surface)
Fabric
Running Side/Pulley Side Property
Non-adhesive
Running Side/Pulley Side (Color)
Light gray
Product Characteristics
Slider Bed Suitable
Yes (Only small belt load)
Carrying Rollers Suitable
Yes
Troughed Installation Suitable
No
Antistatically Equipped
Yes
Additional Technical Information
Chemical Resistance Class
2 (These indications are not guarantees of properties)
Installation and Handling Instructions
Do not go below initial elongation (epsilon) ~ 0.3%.; Install the slack belt and tension until running perfectly under the full belt load.
Limitations
dmin = 25 mm in case belt speed is < 5 m/sec - dmin = 30 mm in case belt speed is < 12 m/sec or belt is specified by machine manufacturer - dmin = 40 mm in case belt speed is > 12m/sec. Info for machine manufacturers: dmin depends on belt path. Keep belt edges free of any installation/machine contact; This product has not been tested according to ATEX standards (atmospheres with explosion risk - ATEX 95 regulation or EU directive 94/9) and therefore is subject to user's analysis in the respective environment.
Notes
All data are approximate values under standard climatic conditions: 23ºC/73ºF, 50% relative humidity (DIN 50005/ISO 554), and are based on the Master Joining Method.
