All Categories > Industrial Hose Fittings, Couplings & Clamps > Brass Fittings > Brass Push-On Fittings > Item # 270AT  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # 270AT, Tool for Push-On Fittings






Features:
  • Cuts push-on style hose and inserts the fitting.
  • Built-in cutter slices through 1/4" - 3/4" ID reinforced push-on hose without fraying.
  • Clamp hose into tool's vice and apply light pressure on handle to drive in the fitting.
  • Tool has four 7/16" diameter mounting holes for bench mounting
  • Overall size is 13-1/2" long x 2-3/8" wide x 7" height.
Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.

Safety Alert: Boss couplings and the steam quick disconnects are the only Dixon couplers recommended for steam service





Specifications  · Instructions

Specifications

Size

All

Length

13-1/2 in

Width

2-3/8 in

Height

7 in


Instructions
Assembly Instructions:
  • Trim hose end with smooth square cut
  • Lubricate either push-on fitting, hose or both.
  • Insert push-on fitting into hose until first barb is in hose.
  • Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.

    Disassembly Instructions:


  • Leaving push-on fitting in place, make a 1" cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.
  • With firm grip on hose, give a sharp downward pull to release the fitting from the hose.