Special Application Couplings
ics-quick-disconnect-couplings-special-application
.jpg "FD69 Series Arc Latch - High Pressure Water Blast (10,000 psi)")
FD69 Series/ Arc Latch™ - High Pressure Water Blast (10,000 psi)
(21)- The FD69 Series "Arc Latch™" design has a greater surface contact area for long service life in rugged high-pressure and water blast applications. The maximum operating pressure is 10,000 psi with 40,000 psi minimum burst pressure.
- Safety sleeve lock guards against accidental disconnection.
- Smooth bore "straight through" design for high flow.
- Heavy duty back up ring to prevent O'Ring extrusion.
- Available in plated steel and stainless steel for added corrosion resistance.
- Standard seal material - Buna-N.
- Standard body material - Zinc plated steel, Stainless steel.
FD14 Series/ Drain Coupling
The FD14 Drain Coupling is designed to serve as a drain port for use with systems such as the Eaton FLOCS (Fast Lube Oil Change System) as well as providing a purging port for use during prefill operations.- Low-Profile, with multiple sealing mechanisms
- O-ring - primary seal
- Metal-to-metal - Secondary seal
- Protective cap - Secondary seal
- Push-To-Connect female half for easy one-hand operation
- Broad range of standard thread styles for male half
- Utilizes a Copper-Crush gasket to seat against the port face
- Standard male half seal material - Viton
- Standard female half seal material - Buna-N.
- Standard body material - Zinc plated steel with zinc die-cast valve
- Rubber molded cap
- Standard material - Buna-N.
FD15 Series/ Oil Sampling Valve
(5)- FD15 Oil Sampling Valve:In-line sampling of system fluids is made without system shutdown, usually in less than one minute, and without fluid contamination.
- Application:Engine oil, lubricating oil, transmission fluid and hydraulic fluids in mobile construction equipment, military vehicles, trucks and stationary equipment.
- For best results, Eaton FD15 Oil Sampling Valves should be installed in dynamic fluid lines in low pressure and return lines. If only one sampling point can be chosen, it should be in the return line, upstream of any return line filter. This will insure a representative sample of all components in the fluid system for their present condition.
- Construction:Corrosion resistant plated steel with brass internal components and Buna-N seal.
- Operating Temperature Range: -65ºF to +275ºF
- Minimum Burst Pressure:1200 psi
- Minimum Particle Restriction:500 microns
- Maximum Torque to Operate:10 in. lbs.
- Note: This valve IS NOT intended for aerospace applications.
FD90 Series/ SAE J1502 Interchange
(21)- The FD90 Series Diagnostic coupling is designed to connect and disconnect pressure gauges to hydraulic systems, eliminating the need for permanent gauges. The maximum operating pressure is 7,000 psi.
- Automatic sleeve for one hand push-to-connect operation.
- Flush face valving provides minimal fluid loss and low air inclusion.
- Self-sealing valve design allows connection and disconnection at 500 psi.
- Broad range of end configurations for system accessibility.
- Standard seal material - Buna-N.
- Standard body material - Zinc plated steel.
